[an error occurred while processing this directive]

Contact: nolimits@cts.com

Process For Removing the Throttle Body in a 1995 Dodge Neon SOHC:


<ol>
<li>Loosen screw clamp attaching clean air hose to airbox.</li>

<li>Loosen screw clamp attaching clean air hose to throttle body.</li>

<li>Remove clean air hose from throttle body, airbox, and small hose
attached to clean air hose.</li>

<li>Remove throttle cable from throttle cable seat.</li>

<li>Remove speed control cable from throttle cable seat.</li>

<li>Remove transmission kickdown cable.</li>

<li>Remove throttle position sensor lead.</li>

<li>Remove sensor from idle air control motor.</li>

<li>Remove throttle body fastening bolts (on top of TB).</li>

<li>Remove fastening bolts (2) from bracket.</li>

<li>Remove vapor reclamation hose from throttle body.</li>

<li>Attempt to remove throttle body.</li>

<li>If throttle body does not move, use rubber mallet to loosen.</li>

</ol>

<p>To replace, repeat above steps in reverse</p>

[an error occurred while processing this directive]