020198

POPPING/CREAKING NOISE IN FRONT SUSPENSION, SUPERSEDES TSB 02-02-97 REV. A

INVOLVES INSPECTING/REPLACING AS NEEDED BOTH FRONT WHEEL BEARINGS, UPPER STRUT MOUNTS, ENGINE MOUNTS AND LUBING THE DRIVESHAFTS

212395

TRANSAXLE SLIPS MOMENTARILY DURING LIGHT THROTTLE 2-3 UPSHIFTS

ADJ. THROTTLE PRSS. AND/OR INSTALL REVISED KICKDOWN BRACKET ON THE THROTTLE BODY AND/OR REPLACE VALVE BODY

211394

AUTOMATIC TRANSMISSION HARSH OR ERRATIC SHIFTS

ADJUSTING THE TRANSMISSION THROTTLE PRESSURE KICK DOWN CABLE.

210696

SLIPS IN REVERSE AT LOW TEMPERATURES

INVOLVES INSTALLING A REVISED LOW/REVERSE SERVO PISTON

183995

'TICKING" NOISE FROM ENGINE COMPARTMENT

INVOLVES SELECTIVELY ERASING AND REPROGRAMMING THE POWER TRAIN CONTROL MODULE WITH NEW SOFTWARE

183895

ENGINE RPM DOES NOT DECREASE WHEN SHIFTING

PCM FLASH

183695

EGR MONITOR FAULTS AND OR SAG/HESITATION

PCM FLASH

182694

CHECK ENG. LIGHT ON "EVAP PURGE FLOW MONITOR FAILURE" FLASH CODE 31

INVOLVES REPROGRAMMING THE POWERTRAIN CONTROL MODULE WITH NEW SOFTWARE.

182594

IMPROVED IDLE QUALITY ON COLD START UP

INVOLVES REPLACING THE POWERTRAIN CONTROL MODULE WITH A NEW ONE THAT INCORPORATES REVISED SOFTWARE.

182095

INCREASED THROTTLE EFFORT TO MOVE ACCELERATOR PEDAL FROM IDLE POSITION.

REMOVING THE THROTTLE BODY AND CLEANING ANY RESIDUE THAT HAS ACCUMULATED ON THE THROTTLE BLADE & THROTTLE BODY CORE. REV 18-20-95 ADD PCM

181894

SAGS, HESITATION, SURGE AND/OR OCCASIONAL SHUDDER

INVOLVES REPLACING THE PWT CONTROL MODULE (PCM) & ON MANUAL TRANSAXLE VEH.BUILT PRIOR TO 1/28/94, REPLACING CRANKSHAFT POSITION SENSOR.

181594

CHECK ENGINE LIGHT ON, CODE 65, POWER STEERING SWITCH FAILURE

MODIFYING A WIRING CIRCUIT FOR THE PCM BY GROUNDING PCM CAVITY #56 TO PREVENT IT FROM SETTING A POWER STEERING FAULT.

181395

WHISTLE NOISE FROM PCM

DESCRIBES OPERATIONAL CHARACTERISTIC OF THE PCM AND NO REPAIRS SHOULD BE ATTEMPTED.

181097

INTERMITTENT SINGLE CYLINDER MISFIRE AND/OR MIL ILLUMINATED

INVOLVES THE REPLACEMENT OF THE SPARK PLUG IN THE EFFECTED CYLINDER WITH A REVISED SPARK PLUG

180794

IDLE ROUGHNESS ACCOMPANIED BY STEERING WHEEL SHAKE

REPAIR INVOLVES SELECTIVELY ERASING AND REPROGRAMMING THE PCM, INSTALLING A STEERING WHEEL DAMPER, AND REPLACING THE CLOCK SPRING.

180697

ENGINE SLOW CRANK/MIL ILLUMINATED - IAC DTC HEX $19 SET

INVOLVES CLEANING OR REPLACING THE POSITVE BATTERY CABLE, REPLACING THE PCM ON EARLY VEHICLES AND SELECTIVELY REPROGRAMMING THE PCM

180496

ERRATIC IDLE AND MIL ILLUMINATION

INVOLVES REPLACING THE THROTTLE POSITION SENSOR/O-RING OR THE THROTTLE BODY

180395

CHECK ENGINE LIGHT ON "VACUUM LEAK FOUND (IAC FULLY SEATED)"

SELECTIVELY ERASING AND REPROGRAMMING THE POWERTRAIN CONTROL MODULE WITH NEW SOFTWARE (CALIBRATION CHANGE).

140694

CHECK ENGINE LIGHT ON,CODE 21, UP OR DOWNSTREAM O2S SHORTED TO VOLTAGE

BULLETIN CONTAINS INFORMATION ON REPROGRAMMING THE POWERTRAIN CONTROL MODULE RATHER THAN REPLACING THE MODULE.

110496

EXCESSIVE EXHAUST NOISE/VIBRATION DURING/AFTER UNDERBODY CONTACT WITH WATER

INVOLVES ALIGNING THE EXHAUST PIPE IN THE TUNNEL AND STRAIGHTENING THE TUNNEL HEAT SHIELD

090596

EXCESSIVE ENGINE MOTION/ENGINE MOUNT WEAR CHARACTERISTICS

DESCRIBES NORMAL OPERATION AND APPEARANCE OF THE ENGINE MOUNTS.

084894

MDS/DRB III USAGE

MDS & DRB III (STAND ALONE) MUST BE OPERATING WITH RELEASE 14 OR HIGHER WHEN USED ON '95 MY VEHICLES.

083996

VEHICLE WILL NOT START-STARTER SOLENOID CLICKS WITH NO MOTOR ENGAGEMENT

INVOLVES REPLACEMENT OF THE STARTER WITH A REVISED PART

082496

SPEED CONTROL INOP OR SPEED CONTROL SURGES DURING OPERATION

INVOLVES REPLACING THE SPEED CONTROL SERVO AND WIRING CONNECTOR AND ADDING A SPLASH SHIELD EXTENSION

070797

ENGINE COOLANT USAGE

PROVIDES THE ALLOWABLE TYPES OF ANTIFREEZE IN CHRYSLER VEHICLES